RSXS.md

@@ -282,17 +282,17 @@ mydata.header[3].UB   # return dictionary of UB metadata
 
 1. There is no beam.
 - Make sure there is beam in the storage ring.
-- Check if main shutter and branch shutter are open. Check EPS
+- Check if main shutter and branch shutter are open. If any shutter cannot be openned, Check beamline EPS and call stuff.
 - Check if ID and mono energy setpoints are consistent.
 - Check beam on the exit slit camera from m3r_align panel. 
 - If there is no beam and piezo voltage is very high (-12V or 40V), try tweak it back to zero.
 
 2. `m3r_align` doesn't work.
-- This happens when the code had hard time to determine where the peak was. Try tweak the piezo voltage back to zero and adjust 
-- check exposure time (t(s)) of the camera.
+- This happens when the code had hard time to determine where the peak was. Try tweak the piezo voltage back to zero and adjust m3r pitch.
+- When the photon energy is too high (> 2.1 keV) or the mono and ID energies are very different, photon counts can be low. Try increase exposure time (t(s)) of the camera.
 
 3. ID gets stuck.
-- change mode on the ID screen, wait till it's done, and change the mode back. This will reset the ID.
+- change mode on the ID screen, wait until it's done, and change the mode back. This will reset the ID.