RSXS/Kappa-Diffractometer/Alignment.md

@@ -23,8 +23,9 @@ Sync_PI_Motor()
     * offset (should be "frozen")
 5) check d3 position using a fine scan on either side and erf fit to locate center precisely
 6) if d3 vs d4 offset is off: update offset value in DB:
-
-       gedit /net/s29dserv/xorApps/epics/synApps_5_8/ioc/29idKappa/29idKappaApp/Db/tthOffsetSelector.db
+```
+gedit /net/s29dserv/xorApps/epics/synApps_5_8/ioc/29idKappa/29idKappaApp/Db/tthOffsetSelector.db
+```
 7) reboot 29idKappa (run on Junebug) and sync PI motor again.
 8) check mesh and slits:
 ```python